Adventures in tramming!

Adventures in tramming!

Postby ScrapMetal » Wed Sep 12, 2012 3:30 pm

For my next trick I'm going to be doing some milling on the SOSE cylinders so before I get started I'm planning on getting the mill trammed properly. I read a lot of good things about the EZ-Tram - http://www.eztram.com/ so I figured it would be worth a try.

Image

To head off all the helpful folk - I know that the plastic caps on the legs need to be removed! I just didn't have time to get everything set up this afternoon so I figured I'd wait until I was actually going to use it to pull off the protective "boots".

The one issue I may run in to is that the indicator doesn't have very much travel so if the head is way off I'm going to have to do a lot of "fudging" until it gets within a usable range. That could get a little frustrating.

I'll take some more pics and let you know how it goes as I get the chance.

Thanks,

-Ron
Wells-Index 860 Mill
South Bend 11" Lathe
Queen City Shaper
User avatar
ScrapMetal
Site Admin
 
Posts: 225
Joined: Thu Feb 02, 2012 3:39 am

Re: Adventures in tramming!

Postby Hawkeye » Wed Sep 12, 2012 7:50 pm

If there's a chance your head could be way out you might try a plunger-type dial indicator first. Can't be more than an inch out, right? :lol:

If you need a way to hold the DI, I'm picturing an arm to fit your boring head with the end faced and threaded for a 1/4" bolt to go through the bracket on the back of the indicator. Get the head trammed within 0.001 with that, then switch to your good indicator.
Mike
User avatar
Hawkeye
 
Posts: 44
Joined: Sun Feb 05, 2012 10:04 pm
Location: Kelowna, BC, Canada

Re: Adventures in tramming!

Postby ScrapMetal » Wed Sep 12, 2012 11:38 pm

That's a very good idea, no wonder I didn't think of it. :slaphead: I think the Noga arm/holder I'm using will take a plunger dial indicator as well. I wouldn't have to change anything even just switch from the plunge-type to the Mitutoyo.

I'll give that a try tomorrow.

Thanks much,

-Ron
Wells-Index 860 Mill
South Bend 11" Lathe
Queen City Shaper
User avatar
ScrapMetal
Site Admin
 
Posts: 225
Joined: Thu Feb 02, 2012 3:39 am

Re: Adventures in tramming!

Postby ScrapMetal » Sun Sep 16, 2012 8:48 pm

I finally had the time to try and tram the beast today. Using the EZTram simplified things for sure. There was still much cursing and gnashing of teeth though. If I can avoid it I am never going to change the angle of the head again! ;)

Image

I did run in to some trouble in that it would have been nice to have a bit more travel with the dial indicator but I didn't have to resort to using my plunger dial indicator.

Regards,

-Ron
Wells-Index 860 Mill
South Bend 11" Lathe
Queen City Shaper
User avatar
ScrapMetal
Site Admin
 
Posts: 225
Joined: Thu Feb 02, 2012 3:39 am


Return to Milling Machines

Who is online

Users browsing this forum: No registered users and 1 guest

cron